Humidity detector                                         Fha936wd.JPG (23477 bytes)

Humidity sensor for detection of water especially in building construction for measurements at non-visible sites.
Indirect humidity measurement by determing the electrical conductance. The measured electrical resistance depends on the humidity within the material.

 

Specifications of FH A936 WD
Measured values: < 10%: no water present
> 10%: water present
Handle: plastic with integrated electronics Ø 40 mm, length 130 mm
Measuring probes: stainless steel, not insulated
• rigid with sharp measuring tip, Ø 3 mm, length 50 mm
• rigid with rounded measuring tip, Ø 3 mm, length 200 mm
• spring steel strip, width 5 mm, length 200 mm
Signal output: ALMEMO® (approx. 0 to 2 V)
Power supply:  7,5 to 15 V
Current consumption: max. 10 mA
Weight: 260 g
Application range: 0 to 60 °C (nominal temperature 23 °C ± 2°C),
10 to 90 % r.H. not condensing

 

Order No. Description
FH-A936-WD Humidity sensor for determination of water especially in building construction for measurements at non-visible sites.

{Back}